Craftsman 31BS62EE799 Operator's Manual page 25

Problem
Unit fails to discharge snow
Chute fails to easily rotate 180
degrees
TROUBLESHOOTING
Cause
1. Chute assembly clogged.
2. Foreign object lodged in auger.
3. Auger cable in need of adjustment.
4. Auger belt loose or damaged.
5. Shear pin(s) sheared.
1. Chute assembled incorrectly.
1. Stop engine immediately and disconnect spark plug wire. Clean
chute assembly and inside of auger housing with clean-out tool
or a stick.
2. Stop engine immediately and disconnect spark plug wire.
Remove object from auger with clean-out tool or a stick.
3. Adjust auger control cable. Refer to Assembly section.
4. Replace auger belt. Refer to Service and Maintenance section.
5. Replace with new shear pin(s).
1. Disassemble chute control and reassemble as directed in the
Assembly section.
25
Remedy