Asus Q170M2/CDM/SI Manual page 21

3. Chassis intrusion header (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The chassis
intrusion sensor or switch sends a high-level signal to this connector when a chassis
component is removed or replaced. The signal is then generated as a chassis intrusion
event.
The chassis intrusion detection feature is disabled by default. To enable it, set the Chassis
Intrude Detect Support item in the BIOS to [On]. See section 2.7 Monitor menu in
chapter 2 of this user manual for details.
Q170M2/CDM/SI
Q170M2/CDM/SI Chassis intrusion connector
4. Intel ME jumper (3-pin DIS_ME)
®
This jumper allows you to enable or disable the Intel
pins 1-2 to enable (default) the Intel
Q170M2/CDM/SI
Q170M2/CDM/SI Intel
Disable the Intel
ASUS Q170M2/CDM/SI
CHASSIS
ME function and to pins 2-3 to disable it.
®
DIS_ME
1 2
Normal
(Default)
ME jumper
®
ME function before updating it.
®
ME function. Set this jumper to
®
2 3
Disable ME
1-13