Table of Contents
Advertisement
HOW TO USE THE
APPLIANCE
FIRST TIME USE
See the section DAILY USE for instructions on selecting and starting
a programme.
F
IRST CYCLE OPERATION
Remove any manufacturing debris:
1. Select the "Cotton" programme with a
temperature setting of 60 °C.
2. Pour a small quantity of detergent
powder into the main wash compartment
of the detergent dispenser (maximum 1/3
of the quantity the detergent manufacturer
recommends for lightly soiled laundry).
DAILY USE
For more information on functions, a more detailed
guide may be requested or downloaded from the website
following the instructions given on the last page.
1.
LOADING LAUNDRY.
• Prepare the laundry, following the
recommendations given in the section
"HINTS AND TIPS". - Open the door and
load the laundry into the drum, without
exceeding the maximum load capacities
indicated in the Programme Chart.
• Close the door, pressing until the
latch audibly locks, and check
that there is no laundry trapped
between the door glass and the rubber seal.
2.
OPEN THE WATER TAP
Check that the washer dryer is
connected correctly to the water mains.
Open the water tap.
3.
SWITCHING ON THE WASHER DRYER
MACHINE .
Press button
; the lamp
4.
SELECTING A PROGRAMME AND
CUSTOMISING A CYCLE. The following
functions are possible with this appliance:
• Wash only
• Wash and dry
• Dry only
10 10
3. Start the programme without loading the
washer dryer machine (with empty drum).
Wash only
Select the required programme with the
PROGRAMME selector dial. The duration of the
wash cycle is shown on the display. The washer
dryer machine automatically displays the
maximum temperature and spin speed settings
possible for the selected programme. Adjust
the temperature and/or spin speed settings if
needed with the relative buttons.
• Press button "Temp°" to cycle through progressively
lower temperature settings until cold wash is set ("-
-") shown on display.
• Press button "Spin speed" to cycle through
progressively lower spin speed settings until the
Pressing the button again sets the highest
possible setting.
Select the required options (if necessary).
• Press the button to select the option; the
respective button lamp illuminates.
• Press the button again to cancel the option; the
lamp extinguishes.
! If the selected option is not compatible with the
programme set, an error warning tone sounds
option is not selected.
Wash and dry
.
To wash and dry a load with no interruption
between the wash and dry cycles, make sure
that the load does not exceed the maximum
permissible drying load for the selected
programme (see the column "Max. load for drying
cycle" in the Programme chart).
.
. The
Advertisement
Table of Contents
