Ikelite 6184.95 Instruction Manual page 14

Digital housing for nikon s9500
Table of Contents

Advertisement

Control Maintenance -
Slide the shaft back into the control gland and gently slide it back and
forth a few times without fully removing the shaft from the gland.
Replace the knob noting the flat area on the shaft. The set screw in the
knob should tighten down against the flat area on the control so the
knob does not turn on the shaft.
Control Shaft
Tighten set screw down
against this flat area
when replacing the knob.
Housing
14
continued
Diagram A
Housing
Lubricate end of shaft
before reinserting into
gland
Diagram B
Gland
Loosen set screw
(allen wrench required)
Lubricate shaft
Pull out knob to
expose shaft

Advertisement

Table of Contents
loading

Table of Contents