Using The Camera's Built-In Flash; Closing The Housing - Ikelite 6182.78 Instruction Manual

Using the Camera's Built-in Flash

If you are shooting with the camera's built-in flash and the camera lens
is set to the widest angle, you may need to zoom the lens slightly or a
dark area may appear in a lower corner of close-up photographs. The
lens port may block some of the light. Install the Diffuser (included) and
zoom in slightly to eliminate any dark areas noted in your photographs
(You can test this above water). See Diffuser/Deflector Installation, page
13. For the best results, we recommend using an external Ikelite Strobe.
The camera's built-in flash CANNOT be used with optional Wide-Angle or
Accessory lenses.

Closing the Housing

1. Place housing face down in your lap or on a flat surface. Check to see
that there is an o-ring on the housing back, and that it is clean and in its
proper location.
2. Guide the back into the housing front. Once the
back is properly installed, the o-ring should
touch the housing all the way around.
There should be an even gap on each side
of the housing between the housing and
the back.
3. Lift the lid snaps so they are
extended and place each lid snap
into the corresponding hook on the
housing back.
4. To close the housing, push down on the lid snaps until they snap into
place. Lid snaps on opposite sides of the housing should be closed at
the same time. Be sure they are down far enough to engage the lock.
The o-ring seal should now appear as a solid black line.
Lid Hook
Even gap on
all four sides
Lid
Snap
Housing Back
O-ring
11