Table of Contents
Advertisement
Fault
Detergent residue on
the dry laundry.
Drying programme
does not start.
The programme dura-
tion changes during
the wash cycle.
Drum jerks after the
programme starts.
Detergent or fabric
softener drips off the
seal and collects on
the door or in the seal
fold.
Fluff on the laundry.
Fabric softener re-
mains in the detergent
drawer.
The laundry is too
damp.
Cause and troubleshooting
Detergents may contain water-insoluble substances
that deposit on the laundry.
Brush out the laundry after washing and drying.
▶
Door is not closed.
Close the door.
▶
No drying programme is selected.
Select a suitable drying programme.
▶
→ "Programmes", Page 25
The programme operation is optimised electronically.
This may change the programme duration.
Not a fault – no action required.
▶
The unbalanced load detection system eliminates an
imbalance by repeatedly redistributing the laundry.
Not a fault – no action required.
▶
Note: When loading, where possible, place large and
small items of laundry together in the drum. Different
sized items of laundry distribute themselves better
during the spin cycle.
Foam detection system switches on a rinse cycle if
foam build-up is too high.
Not a fault – no action required.
▶
This is caused by an internal motor test.
Not a fault – no action required.
▶
Too much detergent/fabric softener in the detergent
drawer.
When dosing liquid detergent and fabric softener,
▶
observe the marking in the detergent drawer and
do not dose above this.
Fluff has accumulated in the drum.
Run the
Drum Care programme without any
▶
laundry or detergent.
The use of fabric softener is not supported for the se-
lected programme.
Before washing, check whether the use of fabric
▶
softener is supported for the selected programme.
→ "Programmes", Page 25
Unsuitable programme for the type of fabric.
There has been a power cut.
Check whether the lighting in your room or other
▶
appliances are working.
Troubleshooting en
45
Advertisement
Table of Contents
