Table of Contents
Advertisement
en Troubleshooting
Fault
The spin programme
does not start.
Water is leaking out at
the water inlet hose.
Water is leaking out at
the water outlet hose.
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp.
Detergent residue on
the damp washing.
44
Cause and troubleshooting
Start the Spin
▶
Water inlet hose is not correctly/securely connected.
Connect the water supply hose correctly.
1.
→ "Connecting the water inlet hose", Page 14
Tighten the screw connection.
2.
The water outlet hose is damaged.
Replace the damaged water outlet hose.
▶
Water outlet hose is not connected correctly.
Connect the water outlet hose correctly.
▶
→ "Water outlet connection types", Page 14
A low spin speed is selected.
The next time you run a wash cycle, set a higher
▶
spin speed.
Start the Spin
▶
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the Spin
▶
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the Spin
▶
Detergents may contain water-insoluble substances
that deposit on the laundry.
Start the
Rinse programme.
▶
programme.
programme.
programme.
programme.
Advertisement
Table of Contents
