Table of Contents
Advertisement
en Troubleshooting
Fault
flashes.
"H:95" lights up altern-
ately with End.
All other error codes.
The drying time is too
long.
Creasing.
The appliance is not
working.
40
Cause and troubleshooting
Door is not closed.
Close the door.
▶
Laundry is caught in the door.
Remove any trapped laundry.
▶
Drum cleaning is required.
→ "Cleaning the drum", Page 34
▶
The water pressure is low.
See
▶
→ "E:30 / -10 and/or
Malfunction
Switch the appliance off and then on again.
1.
If the message appears again, disconnect the appli-
2.
ance from the power supply for at least 30 seconds
by pulling out the plug or by switching off the relev-
ant circuit breaker in the fuse box.
a If the fault was a one-off, the message disappears.
If the message appears again, call the after-sales
3.
service. Please specify the exact error message
when calling.
→ "Customer Service", Page 49
The ambient temperature is greater than 30 °C.
Ensure that the ambient temperature is below 30
▶
°C.
Insufficient air circulation at the appliance's installation
location.
Ventilate the appliance's installation location.
▶
Fluff has accumulated in the drum.
Run the
Drum Care programme without any
▶
laundry or detergent.
The load is too large.
The laundry lies in the drum for too long after drying.
Remove the laundry from the drum as soon as the
1.
drying programme has finished.
Spread the items of laundry for cooling.
2.
Unsuitable programme for the type of fabric.
Set the suitable programme for the type of fabric.
▶
Easy-Care fabrics are dried for too long.
The mains plug of the power cord is not plugged in.
Connect the appliance to the power supply.
▶
", Page 39
Advertisement
Table of Contents
