yuna Calor EBK2 Instruction Manual page 45

 Liquid on the sensors.
 You used your fingertip.
 You used unsuitable cookware with
sharp edges.
 You used an unsuitable detergent,
e.g. an abrasive.
Some cookware make cracking or clicking noise.
 Your cookware is produced with
layers made of different kinds of
metal.
The appliance makes humming noise when used on a high heat setting.
 Caused by induction-cooking.
Noise caused by the fan inside the appliance.
 The cooling-fan the appliance is
equipped with
electronics from being overheated. It
may continue to run even after you
have switched the appliance off.
Cookware does not become hot and the relevant symbol is displayed.
 Cookware cannot be detected,
because it is unsuitable, too small or
improperly
cooking zone.
The appliance or a cooking zone has been switched off automatically and
unexpectedly, an acoustic signal sounds and an error code is displayed
(typically alternating with one or two digits on the timer-display).
 Technical malfunction.
If the appliance shows a malfunction not noted on the schedule above or if you
have checked all items on the above schedule but the problem still exists, please
contact a service department.
The sensors are difficult to operate.
The glass ceramic is scratched.
protects
positioned on
 Dry the sensors.
 Use the bottom of your top phalanx.
 Use suitable cookware.
 Use suitable detergents.
 This is normal for such a cookware
and does not indicate a malfunction.
 Normal operating condition, but the
noise should decrease or disappear
after decreasing the heat setting.
 Normal operating condition. Do not
the disconnect the appliance from the
mains while the fan is running.
 Use suitable cookware which meets
the diameter of the cooking zone.
the Place cookware on the centre of the
cooking zone.
 Note the complete error-code,
disconnect the appliance from the
mains and contact the aftersales
service.
45