yuna Calor EBK2 Instruction Manual page 30

and emit heat even if it has stopped operating.
1. When you move the appliance, hold it at its base and lift it carefully. Keep the
appliance in an upright position.
2. The appliance must be transported and installed by at least two persons.
3. When you unpack the appliance, you should take note of the position of its
components in case you have to repack and transport it at a later point of time.
4. Do not put any heavy items on the hob.
5. Only use cookware which is suitable to be used on ceramic glass; otherwise you
will damage the appliance.
6. Do not operate the appliance unless all components are installed properly.
7. The air vents of the appliance or its built-in structure (if the appliance is
suitable for being built-in) must be completely open, unblocked and free of any
kind of dirt.
2. Installation
1. The hob must be installed by a qualified professional. Do not carry
out the installation yourself.
2. Do not install the appliance above cooling equipment, dish washers
or laundry dryers.
3. When installing the appliance ensure optimal heat radiation to
maintain the operating safety.
4. The wall and the reach of the heat radiation above the worktop must
be made of heat-resistant materials.
5. To avoid any damage, the sandwich layer and adhesive must resist
heat.
2.1 Unpacking and positioning
1. Unpack the appliance carefully. Dispose of the packaging as described in
chapter
WASTE MANAGEMENT
2. The appliance may be equipped with a the transport-protection. Be very careful
and do not use any aggressive or abrasive detergents to remove residuals of the
transport-protection.
3. Check that the appliance and the power cord are not damaged.
4. Connect the appliance to a dedicated socket only.
NOTICE
CAUTION!
.
30