Advertisement
4) Fourth step: Fix Support Arm
Tear off the sticker
Fix the balance arm
5) Fiveth step : Install tubeline
Insert tubelline through the arm
6) Sixth Step: Adjust the tubeline
Adjust the tubeline,remove the
Cartridge-car back and forth
Fix the arm on the 8cm right far from
you printer
Tear off the sticker of clamp
Make sure tubline will not meet
printer when printing
Tear off the sticker
Attached the clamp on your printer
and let it parallel with printer
Finished
Make sure the lengh of tubline is
enough to reach the far left and right
Advertisement
