Epson P260 User Manual
  1. Manuals
  2. Brands
  3. Epson Manuals
  4. Printer Accessories
  5. P260
  6. User manual
Epson P260 User Manual

Epson P260 User Manual

Auto take-up reel unit
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
®
Auto Take-up
Reel Unit User's Guide
English . . . . . .
XXXXXXX-XX
XXX-00

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the P260 and is the answer not in the manual?

Questions and answers

Related Manuals for Epson P260

Summary of Contents for Epson P260

  • Page 1 ® Auto Take-up Reel Unit User’s Guide English ..XXXXXXX-XX XXX-00...

  • Page 2: For European Users

    SEIKO EPSON CORPORATION. The information contained herein is designed only for use with this EPSON product. EPSON is not responsible for any use of this information as applied to other products.

  • Page 3: Important Safety Instructions

    For United Kingdom users Use of options Epson (UK) Limited shall not be liable against any damages or problems arising from the use of any options or consumable products other than those designated as Original EPSON products or EPSON Approved products by Epson (UK) Limited.

  • Page 4: Checking The Package Contents

    Before starting: Make sure that the printer is turned off. Remove the paper basket or push the front part of the paper basket to the rear to keep it out of the way.
  • Page 5 4. Plug the other end of the cable connector into the connector on the back of the printer as shown below, then tighten the screws on both sides of the connector.

  • Page 6: Installing The Sensor Unit

    Light emitter 4. Fasten the cable using the cable clamps provided. Use as many of the clamps as necessary to secure the cable.You may need to do this from the back of the printer.
  • Page 7 If you want to use the 2-inch take-up reel core, you need to reverse the flanges on the drive unit and movable unit first. Follow the steps below. 1. Make sure that your printer is turned off. 2. Remove the cap and fastener from the drive unit.
  • Page 8 3. Remove the flange. 4. Reverse the flange so that the smaller knob is positioned on the outside, then replace it on the drive unit. 5. Replace the cap and fastener, which you removed in step 2, on the drive unit. 6.

  • Page 9: Specifications

    When you use the unit, see the Reference Guide. Specifications Note: This product is designed for use with printer models P260 (A, B or C) This product conforms to CE marking requirements in accordance with EC Directive 898/336/EEC. Usable paper width Paper length Max.
  • Page 12 Printed in Japan 00.xx-xx...

Table of Contents

Save PDF