Gravely ZT 34 Operator's Manual page 20

5. Use steering levers to move the unit.
6. Disengage PTO to stop mower blades.
TRANSPORTING UNIT
ALWAYS shut off engine, set parking brake,
remove key and properly remove fuel when
transporting unit on a truck or trailer. Tie unit
down securely. Do not tie down by linkages,
guards, cables or other parts that may be
damaged.
FOR BEST PERFORMANCE
• Cut grass when it is dry.
• Keep mower blades sharp.
• Keep mower deck properly leveled.
• Do not set height of cut too low. For
very tall grass, mow twice.
• Do not travel too fast.
• Mow with the engine set at full throttle.
• When mulching, only remove one-third
of grass length per cutting.
• Discharge clippings into areas already
cut.
• Vary cutting pattern with each mowing.
• Do not allow grass or debris to collect
inside of mower deck. Clean after
each use.
MOVING UNIT MANUALLY
(Figure 8)
WARNING: DO NOT disengage
or bypass transmission and coast
downhill.
Pull the bypass lever out and lock it in place
and then release the parking brake to push
the unit by hand.
Push the bypass lever in to drive the unit
normally.
NOTICE: There are two bypass levers (one
on each side of the unit).
1. Bypass lever pulled out to push the unit
by hand.
2. Bypass lever pushed in to drive the
unit.
EN - 20
Figure 8
1
2