1
11
10
9
8
1. Seat
2. Detent Pin
3. Operator Presence
Switch Wires
4. Seat Retainer Slot
Cleaning Battery and Battery Cables
(Figure 20)
1. Remove battery from unit (see Battery
Removal and Installation on page 18).
2. Clean or service battery away from unit.
Remove corrosion from battery terminals
and cable connections with wire brush,
then wash with a weak baking soda
solution.
3. Install battery on unit (see Battery
Removal and Installation on page 18).
Charging the Battery
(Figure 20)
WARNING: FROZEN BATTERIES
CAN EXPLODE and result in death
or serious injury. DO NOT charge a
frozen battery. Let the battery thaw
before charging.
Follow First Aid directions for contact with
battery fluid.
• External Contact: Flush with water.
5. Battery Hold Down
Bracket
6. Battery
7. Cross Brace
8. Negative (–) Terminal
Figure 20
• Eyes: Flush with water for at least 15
• Internal Contact: Drink large quantities of
• In case of internal contact, DO NOT
IMPORTANT: DO NOT fast charge.
Charging at a higher rate will damage or
destroy battery.
IMPORTANT: ALWAYS follow information
provided on battery and battery charger.
Contact battery and battery charger
manufacturers' for detailed instructions.
1. Remove battery from unit (see Battery
2. Place battery on bench or other well-
3. Connect positive (+) lead of charger to
4. Charge battery according to battery
GB - 19
9. Negative (–) Cable
10.Positive (+) Cable
11.Positive (+) Terminal
minutes and get medical attention
immediately!
water. Follow with Milk of Magnesia,
beaten egg or vegetable oil. Get medical
attention immediately!
induce vomiting!
Removal and Installation on page 18).
ventilated area.
positive (+) terminal, and negative (–)
lead of charger to negative (–) terminal.
charger and battery manufacturers'
instructions.
2
3
4
5
6
7
OE0028