FibroPool FH135 Installation And User Instructions Manual page 12

HEATING mode – Sunshine Sign
CLOCK key：Time setting (NOT AVAILABLE ON MOST MODELS)
➢
Press this key, then SET. Use the up and down arrows to set the current time. Use M button to
swap between hour/ minute settings. There is NO TIMER. This is only to set the time. You DON'T
have to set the time, it does not affect the operation of the heater at all.
UP AND DOWN ""and""key：
➢
Press ""and""key to increase or decrease the values.
ADJUSTING THE TEMPERATURE: MAKE SURE THE HEATER IS ON, THEN USE THE UP
AND DOWN ARROWS TO ADJUST THE TEMPERATURE. (temp must be set individually for
heating, cooling and auto modes)
"SET" key：
➢
Press this key to enter the fault query state, and then press this key to query other fault
displays in the current state.
Press and hold SET key to enter parameter state, then press "MODE" key to enter the setting.
You can set the parameters by pressing """" key, press "SET" key to set other parameters.
Exit the parameter setting state automatically if there is no operation within 5 seconds.
On occasion, you may see a square with Rain drops in it. This means the heaters coils are too cold
and its in defrost mode. Do not be alarmed, as it is a normal function in colder air temperatures.
FOR A HOMEOWNER, ONLY THE HEATING AND COOLING TEMPERATURES NEED TO BE
ADJUSTED. SIMPLY PRESS MODE TO GO TO HEATING, AND USE THE UP AND DOWN
ARROWS TO ADJUST. ADJUSTING OTHER SETTINGS CAN AFFECT THE PERFORMANCE
AND OPERATION OF THE HEATER. WE DO NOT RECOMMEND THAT HOMEOWNERS
CHANGE ANY OTHER OPERATIONAL SETTINGS.
V.23.02 FIBROPOOL USA