Table of Contents
Advertisement
Problem
The displayed
remaining time
changes.
There is an unusual
noise or vibration.
There is noise when
the water drains out.
The electricity supply
cuts out while the
appliance is on.
A circuit breaker trips
and the electricity
supply is cut.
The water supply is
disrupted.
The display is not
clear.
NA-107VC6_WHK_Eng.indb 33
-
The remaining time is estimated and corrected continually.
Thus, the time displayed may change.
-
There may be metal items in the drum.
-
The anchor bolts may not have been removed. (P.36)
-
The appliance may be on a sloping or unstable surface.
If none of the above is the cause, contact your local
Customer Service Centre.
-
This is normal; it is noise generated by the operation of
the drain pump.
-
The appliance stops operating. When power is restored, it
resumes operation from the point that it had stopped.
-
The appliance stops operating. When the breaker is reset,
it resumes operation from the point that it had stopped.
However, we recommend that the reason that caused the
breaker to trip is found and steps taken to solve it.
-
When the water is supplied again, it may be impure at first.
You have to disconnect the water supply hose and drain
away the impure water through the tap. Make sure that the
water supply hose has been reconnected before using the
appliance.
-
The appliance may be in a brightly lit or sunlit area.
Fault Checklist
Cause
Troubleshooting - 33
2018-8-1 15:03:14
Advertisement
Table of Contents
