Table of Contents
Advertisement
Mind the following guidelines before you replacing the storage drives:
• If the computer has only one hard disk drive, install the hard disk drive in the slot
• If the computer has only one M.2 solid-state drive, install the solid-state drive in the slot
• The M.2 solid-state drive slots support both SATA solid-state drive and Non-Volatile Memory Express
(NVMe) solid-state drive. If you install two M.2 solid-state drives, ensure that the two M.2 solid-state
drives are of the same type.
After replacing the storage drives, you might need to configure the storage drive boot order in the ThinkPad
Setup program. Ensure that you select the correct storage drive when you configure the settings.
Slot
Slot label on the computer
a
b
c
d
Removal steps of the hard disk drive and hard disk drive cable
b
a
d
c
Corresponding menu selection in ThinkPad Setup
ATA hard disk drive0
ATA hard disk drive1
ATA hard disk drive3 or NVMe1
ATA hard disk drive2 or NVMe0
1
.
Chapter 9
Removing or replacing a FRU
a
.
d
.
67
Advertisement
Table of Contents
