Table of Contents
Advertisement
Commissioning
6.6 Commissioning SITRANS TF with HART
6.5
Commissioning SITRANS TF with 4 ... 20 mA
Condition
Before you start, note the following safety notes:
• General safety notes (Page 21)
• Basic safety notes: Installing/mounting (Page 27)
• Basic safety notes: Connecting (Page 41)
• Basic safety notes: Commissioning (Page 67)
Read the entire device manual in order to achieve the optimum performance of the device.
Procedure
1. Mount the device.
Mounting the SITRANS TF single chamber housing (Page 35)
Mounting the SITRANS TF dual chamber housing (Page 36)
2. Connect the device.
Connecting the SITRANS TF single chamber housing (Page 53)
Connecting the SITRANS TF dual chamber housing (Page 60)
3. For devices with intrinsically safe protection type, use an isolating power supply that
corresponds to the requirements of the relevant type of protection.
4. Switch on the power supply.
Switching on the supply voltage (Page 67)
5. Wait for 2 seconds.
After this startup time, the device is operational.
6. Wait 5 minutes to get exact measured values.
7. If you want to change the factory settings, configure the device using the keys or the USB
modem and the SIPROM T parameter assignment software.
– Read the operating instructions for information on this.
8. Lock the device.
– Read the operating instructions for information on this.
6.6
Commissioning SITRANS TF with HART
Condition
Before you start, note the following safety notes:
• General safety notes (Page 21)
• Basic safety notes: Installing/mounting (Page 27)
70
SITRANS TH100/TH100Slim/TH320/TH420/TR320/TR420/TF320/TF420
Compact Operating Instructions, 07/2021, A5E41865021-AE
Advertisement
Table of Contents
