Table of Contents
Advertisement
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
Intended Use
The machine is intended for dry sanding of wood, plastic, filler and coated surfaces.
ASSEMBLY
1. FITTING THE SANDING PAPER (SEE FIG. A)
WARNING: Always ensure that the sander is
switched off and the battery pack is removed
before making any adjustments.
Remove any dust or dirt from the sanding plate, place
the sanding paper directly onto the base plate. Make
sure the sanding paper is even with the edges of the
sanding plate, and that the dust collection holes in the
hook and loop base and sanding paper are aligned,
with the sanding paper evenly overlapping the detail
sanding plate.
WARNING: Never use your sander without a
sanding paper applied.
2. ATTACHING THE DUST BAG (SEE FIG. B)
Your sander is equipped with a dust bag. To attach, insert
the dust bag into the dust outlet port fully. Check to see if
the dust bag is locked in place.
CAUTION: To prevent the possibility of sanding
dust or foreign body being thrown into your
face or eyes, never attempt to use your sander
without the dust bag properly installed.
3. REMOVE AND EMPTY THE DUST BAG (SEE FIG. C)
For more efficient operation, empty the dust bag after
every 5-10 minutes of operation. This will permit the air to
flow through the dust bag more effectively.
Pull the dust bag out from the dust outlet port of the
sander. Shake out the dust. It is recommended to clean
the filter regularly for better performance.
Fig. A
Fig. B
Fig. C
11
Advertisement
Table of Contents
