Operating Instructions - Wickes PES300 Manual

OPERATING INSTRUCTIONS

NOTE: Before using the tool, read the instruction book carefully.
Intended Use
This tool is intended for dry sanding of wood, plastic, filler and coated surfaces.
ASSEMBLY
1. FITTING THE SANDING PAPER (SEE FIG. A)
WARNING: Always remove the plug from the
mains socket before carrying out any work
on the product.
Remove any dust or dirt from the sanding plate, press
the sanding paper directly onto the base plate. Make
sure the paper is even with the edges of the sanding
plate, and that the dust collection holes in the sanding
plate and sanding paper are aligned, with the sanding
paper evenly overlapping the sanding plate.
To remove the sandpaper, lift one corner of the paper
and pull off from the sanding plate.
WARNING: Never use your sander without a
sanding paper applied.
2. ATTACHING THE DUST BAG (SEE FIG. B)
Your sander is equipped with a dust bag, which is
designed for dust collection task. Insert the dust bag into
the rear dust extraction outlet until it is secure. Pull the
dust bag to make sure it is tightened securely on the dust
extraction outlet.
To remove, pull off the dust bag out directly.
CAUTION: To prevent the possibility of sanding
dust or foreign body being thrown into your
face or eyes, never attempt to use your sander
without the dust box properly installed.
3. REMOVE AND EMPTY THE DUST BAG (SEE FIG. C)
For more efficient operation, empty the dust bag after
every 5-10 minutes of operation. This will permit the air to
flow through the dust bag more effectively.
Pull the dust bag out from the dust outlet port of the
sander. Shake out the dust.
Fig. A
Fig. B
Fig. C
9
8