Table of Contents
Advertisement
TROUBLESHOOTING
Fault
Low efficiency in vacuuming
The sander does not start up
after switch on.
The sander stops during use.
Workpiece grinded is not
smooth. Regular sanding marks
exist.
Low grinding efficiency.
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with household waste. Please recycle where facilities exist.
Check with your local authorities or retailer for recycling advice.
Cause
Too much dust in the dust bag.
Battery depleted.
Defective on/off switch.
Defective motor.
Low battery.
Rough sanding paper. The
density of grit is too low.
Worn sanding paper.
The density of grit of the
sanding paper is too high.
17
Remedy
Clean and empty the dust bag.
Charge the battery.
Contact the service centre.
Contact the service centre.
Charge the battery.
Change a proper sanding paper with higher
density of grit.
Replace it with a new sanding paper.
Change a proper sanding paper with lower
density of grit.
Advertisement
Table of Contents
