Table of Contents
Advertisement
4-3. Installation
• Leave enough space around the unit to allow for an installation/uninstallation of the cover. (The amount of space needed is
shown in the figure below.)
• Screw down the cover with M4 screws as shown in the figure below.
Be sure to fix the four corners to prevent it from falling.
• Install on the metal control panel (indoors) with an effective depth of at least 105mm (4-
Properly install the unit on a stable, load-bearing surface.
Unit installed on an unstable surface may fall and cause injury.
This product is not water-proof. Be sure to install the unit
inside the metal control panel (indoors).
20(
13
/
)
16
* Refer to section
2
Specifications
for the product dimensions and weight.
To reduce the risk of wire shorting, fire, electric shock,
and malfunction, do not install the unit in a condensing
environment, and keep the unit out of water and other
sources of water.
- 16 -
/
in.).
3
16
20(
13
/
)
16
Unit: mm (in.)
Advertisement
Table of Contents
