Brother 888-L91 Operation Manual page 65

f
After the characters are embroidered, cut the threads,
remove the embroidery frame, and then press
"Finished embroidering".
1 End of the embroidering
g
Reposition the fabric in embroidery frame so that the
right side of the letter "F" will be partially inside the
embroidery frame; being careful so letters remain
straight and level. Then reattach frame again so that
the remaining characters ("GHIJK") can be
embroidered.
Memo
• When using the extra large (multi-position)
embroidery frame, align the bottom installation
position with the two pins on the embroidery
frame holder, and then press the frame down until
it snaps into place. The remaining characters
("GHIJK") can be embroidered without
repositioning the fabric.
1 Bottom installation position
h
Press and then press
for
i
Select the character patterns for "GHIJK", and then
press .
j
Press and select
right, and then press
k
Press .
l
Press .
m
Press , and then press
→ The needle is positioned in the lower-left corner of
the pattern. The embroidery frame moves so that the
needle is positioned correctly.
n
Use to align the needle with the end of the
embroidering for the previous pattern.
o
Press .
p
Lower the embroidery foot and press the "Start/Stop"
button to begin embroidering the remaining character
patterns.
Editing All Patterns
.
to rotate 90 degrees to the
.
.
Embroidering E-17
E