Changing The Video Signal Format; Changing The Component Video Output Signal - Sherwood VR-758 User Manual

C H A N G I N G T H E V I D E O S I G N A L
• Depending on the countries, this DVD player conforms to either the NTSC color system for U.S.A, Canada, etc.,
or the PAL for Europe, Australia, China, etc.
If the color system of this DVD player is different from that of your TV monitor and the discs to be played, the
screen may be somewhat hard to see or the picture quality may be poor.
Only in this case, change the video signal format to another.
(For details about the video signal format of your TV monitor or the discs, refer to the operating instruction of
your TV or the disc's jacket.)
• You can set the video signal format to the desired at initial settings, too.
(For details, refer to "When selecting the TV TYPE" on page 43.)
• In the stop mode, press the NTSC/PAL button.
RC
NTSC/PAL
C H A N G I N G T H E C O M P O N E N T V I D E O
• Only during playback of DVD Videos on this unit, the MONITOR COMPONENT VIDEO OUTs of this unit can be
capable of outputting either conventional interlacing video signal or progressively scanned video signal(that can
reproduce high-density pictures with less flicker.)
• When the COMPONENT VIDEO OUTs of this unit are connected to the COMPONENT VIDEO INs of TV or
projector, etc., depending on whether the video signal system of your TV or projector, etc. supports the
conventional interlacing(simply called interlaced) video signals or the progressively scanned(simply called
progressive) video signals(that can reproduce high-density pictures with less flicker), you should select the
corresponding video signal.
Notes:
• When you select the PROGRESSIVE TV, the S-VIDEO and COMPOSITE VIDEO OUTs of this unit cannot
output the video signals, meaning the picture will not be shown.
• When the progressive video signals are input into the non-progressive COMPONENT VIDEO INs of your TV,
etc., the picture may not be shown normally.
Therefore, when the progressive COMPONENT VIDEO INs of TV is not connected to, you should select
INTERLACE TV.
• In the stop mode, press the PROGRESSIVE SCAN button.
RC
PROGRESSIVE
SCAN
• Each time this button is pressed, the video signal
format changes as follows:
MULTI NTSC
• The MULTI is compatible with both NTSC and PAL
formats.
• Each time this button is pressed, the component
video output signal changes and "INTERLACE TV"
or "PROGRESSIVE TV" is displayed on the TV
screen.
39
PAL