Table of Contents
Advertisement
Adjusting the tone(bass and treble)
Enter the tone mode.
8
Each time this button is pressed, the
corresponding tone mode is selected and
shown for 3 seconds as follows:
Note:
When the tone direct function is activated, the
tone mode cannot be entered and "TON DIR"
flickers for 3 seconds.
To listen to a program source without the tone
10
effect.
Adjusting the sound volume balance
Enter the balance mode.
11
"BAL" and the balance level is displayed for 3
seconds.
At the desired tone mode, adjust the
9
tone as desired.
If the tone display disappears, start from the
step 8 again.
Notes:
Extreme settings at high volume may damage
your speakers.
In general, the bass and treble levels are
adjusted to 0.
"TON DIR" is displayed and the sound that
bypasses the tone circuitry will be heard.
To cancel the tone direct function, press this
button again to display "TON CTRL".
Adjust the sound volume balance
12
between the left and right speakers.
If the balance display disappears, start from
the step 11 again.
Note:
In general, the balance level is set to 0.
11
Hide quick links:
Advertisement
Table of Contents
