Assembling The Metal Detector - Clarke MD1500 User Instructions

PREPARATION

ASSEMBLING THE METAL DETECTOR

1. Remove the nut and bolt from the
search coil.
2. Position the lower stem between
the posts on the search coil and
replace the nut and bolt as shown
in Fig 1.
3. Adjust the search coil so that it is
parallel to the ground and tighten
the nut & bolt to lock into position.
4. Insert the lower stem into the
upper stem See Fig 2. Press the
two spring clips on the side of the
lower stem, which will locate into
the holes on the upper shaft.
5. Adjust the length of the shaft.
• When your arm is relaxed and the
coil is just above the ground.
6. Wind the search coil lead around
the stem and insert the connector
into the jack on the control
housing as shown in Fig 3.
BATTERIES
• Only use alkaline batteries.
• DO NOT mix old & new batteries.
1. Remove the battery
compartment cover from the rear
of the control housing.
2. Insert 8 AA batteries into the battery compartment. Make sure that you
follow the polarity symbols inside the compartment.
3. Replace the battery compartment cover.
• Used batteries must be disposed of according to local regulations.
• DO NOT burn or bury used batteries.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
3