Advertisement
CAUTIONS:
TURN OFF ALL POWER AT CIRCUIT BREAKER/FUSE PANEL.
• Read entire Installation Manual before proceeding.
• All wiring should comply with local electrical codes and
requires a qualified electrician
• The total lighting load connected to a STEALTH must not exceed
8 amps (300W on LED). To switch more wattage an electrician can
install a relay.
• Line Carrier Remote Control Systems such as X-10, Levitron or Radio
Shack are incompatible with sensors and cause false activations.
• Do not install sensors on a circuit that feeds motor loads like kitchen
appliances, HVAC equiptment, washer/dryer, or garagedoor openers.
• Sensor must be below and as far as possible away from lights.
• Sensor functions best when the direction of expected
movement is across its detection pattern, not towards the sensor.
• Mount 6-12 feet high for optimum range and detection.
1
How does the STEALTH work?
STEALTH's infrared sensor "sees" small temperature changes caused by the
motion of people or cars within its protection zone and turns on lights auto-
matically. It welcomes visitors and may deter intruders.
How long do the lights stay on?
Lights remain on as long as there
is movement within the protection
zone. Once the zone is vacated,
lights can be adjusted to remain on
from approximately 5 seconds-12
minutes. STEALTH keeps lights on
only when needed and uses just 1
watt to operate, making it extremely
energy efficient.
Can outdoor lights still be turned
on with the light switch?
Yes, STEALTH can be controlled by a
conventional indoor switch or circuit
breaker. Lights can be turned on or
off manually at night only.
Manual Override Mode:
To keep lights on, slowly flip the
switch twice (off-on-off-on) within
2-3 seconds.
To Resume Automatic Mode:
Flip the switch once (off-on) within 2
seconds. Sensor will reset to
Automatic Mode.
Will STEALTH detect animals?
STEALTH may detect large animals.
Having animal trigger the
sensor can give properties a "lived-
in" look. However, you can limit
animal detection by turning down
the sensitivity knob.
2
Time, Sensitivity, and Photocell
adjustments
Control Panel:
Sensitivity:
Increases or decreases the
responsiveness and range of the
sensor. Adjusts from 30% to 100%.
Factory Setting=100%.
Photocell:
Located behind the lens. For night-
only operation, turn the knob all the
way clockwise towards the moon
symbol. For 24-hour operation,
turn the knob all the way coun-
terclockwise towards the sun and
moon symbols. Adjust between
both symbols accordingly for other
operations, such as towards (but not
on) the moon for dusk.
Time: Sets the time that lights will
remain on after the detection zone
is vacated. Can be set from
approximately 5 seconds to 12
minutes.
Factory Setting=5-8 minutes.
Advertisement
