JVC RA-E731B-DAB Instruction Manual page 9

BLUETOOTH
In Bluetooth mode, you can turn on the Bluetooth of your Bluetooth device. Go to the menu
and turn Bluetooth discoverable. From your Bluetooth device, search the radio RA-E731B-DAB
to pair. If the pairing is successful, the display will show <Connected>.
• To increase/decrease the volume, turn the VOLUME knob.
• To pause/resume playback, press the SELECT knob.
• To skip to a track, turn the SELECT knob.
NOTE: The operational range between the unit and the device is approximately 8 meters.
If the signal strength is weak, your Bluetooth receiver may disconnect, but it will re-enter pairing mode
automatically.
For better signal reception, remove any obstacles between the unit and the Bluetooth device.
Compatibility with all devices and media types is not guaranteed.
Some mobile phones with Bluetooth functions may connect and disconnect as you make and end calls.
This is not an indication of a problem with your unit.
AUX IN
AUX in mode plays audio from an external source. Turn the volume low on both the radio and,
if adjustable, the audio source device. Enter AUX mode, then adjust the volume as required.
ALARMS AND SNOOZE
As well as a clock/calendar, there are two wake-up alarms with snooze facility. The alarm
sound for each alarm can use a Buzzer, Digital Radio or FM.
Alarms (Mains Power only)
• Press and hold MODE/ALARM button to enter Alarm menu.
• Turn the SELECT knob to select <Alarm 1> or <Alarm 2> and the knob to confirm.
• Turn the SELECT knob to select and press the knob to confirm below option:
- <Alarm> On / Off
- <Frequency> Daily / Once / Weekends / Weekdays
- <Wake Up time> (Alarm On time)
- <Source> Buzzer / DAB+ / FM
- <Duration> 15 / 30 / 45 / 60 / 90 / 120 minutes
- <Volume> 4-16
• Finally, press INFO/MENU button to return to Alarm menu and press INFO/MENU button
again to exit alarm setting.
NOTE: In Stand by mode active alarms are indicated by displaying the relevant Alarm 1 and/or Alarm 2
icons.
At the set time, the alarm will sound, quietly at first, then gradually building up to the set
volume. To cancel a sounding alarm and switch the radio to standby, press the
button.
Snooze (Mains Power only)
To temporarily silence a sounding alarm, press DIMMER/SNOOZE button. You can change the
snooze period by repeatedly pressing DIMMER/SNOOZE button. Snooze periods are 5, 10, 15
and 30 minutes. The radio returns to standby for the set time period with a snooze countdown
displayed. When the countdown reaches 0 (zero) the alarm is triggered again.
Press the STANDBY button to fully cancel a sounding alarm and switch the radio to standby.
EN
STANDBY