Table of Contents
Advertisement
ZX17U-5N
5. Remove oil using a suction pump. The hydraulic oil tank
capacity up to specified oil level is approximately A.
Model
ZX17U-5N
6. Slowly loosen drain plug (3). Allow oil to drain.
7. After draining oil, remove suction filter (6) with cover (2).
IMPORTANT: When changing hydraulic oil, take care not
to enter foreign matters such as dust, water, or sand
into the hydraulic oil tank.
8. Clean the hydraulic oil tank interior and suction filter (6).
9. Install suction filter (6) and cover (2) to the hydraulic oil
tank.
10. Clean, install and tighten drain plug (3).
11. Add oil until it is between the marks on the oil level
gauge.
12. Bleed air from the hydraulic system.
(Refer to the "Bleed Air from Hydraulic System".
Wrench size:
Tightening Torque: 20 N·m (2 kgf·m, 15 lbf·ft)
13. Replace suction filter (6) at the regular interval to keep
hydraulic oil clean and to extend the service life of the
hydraulic components.
MAINTENANCE
A
26 L (6.9 US gal)
13 mm
2
6
7-41
MABA-07-025
MABA-07-020
3
Advertisement
Table of Contents
