TCM 35 REMOTE CONTROL
The selector LOCAL START/REMOTE START (I6) of the generating set must be switched on LOCAL-
START.
Put the selector „switch board (N7)" on ON.
The coupling of the TCM 35 with the generating set,
ready for remot starting, permits to work far from
the set itself.
The remote control is connected to the front plate
(X1), and/or rear plate, with a multiple connector.
N.B. The remote control TCM 35 can be used only
with machines equipped with control and protection
device EP6 (U7).
For use of TCM 35 see page M21 (start and stop)
of this manual.
MAKE SURE
!
M
38.6
REV.0-03/06