Door Blocking System; Application With Hinged Door Icms; Application With Sliding Door Icms - FRIGOGLASS ICOOL 40/150 C Manual

ENG
Door Open
•
Temperature Reading of the Regulator Sensor.
•
Door Open indicator lit (stable).
•
If door remains open for more than d1 in Mins, it is considered as Door Open Alarm Event:
•
Main display toggles between the Regulator Sensor and "dOP".
•
Door Open indicator stays lit (stable).
•
If door remains open for longer than (d1+d2) in Mins, it is considered as Door Malfunctioning
Event:
•
Main display cycles between the Regulation Sensor, "dOP" (Door Open) and "dSF" (Door
Switch Failure).
•
Door Open indicator stays lit (stable).
•
Master Alarm indication lit (stable).
Compressor On
•
Compressor ON indicator lit during "ON" cycles (stable). This indicator is OΝ whenever the
compressor is On.
For instructions of the functionality of Evocool FFA1 Controller and its related optional features, please
visit the following website link: http://www.frigoglass.com/manuals/

5. Door blocking system

In using the door blocking system, please follow the steps below
5.1

Application with hinged door ICMs

Step 1: Open the door to an angle greater than 110 degrees
Step 2: Rotate the door blocker towards the cabin (as shown in the picture)
Step 3: Door blocker stops on the screw located over the grid (as shown in the picture)
Step 4: Open the door to release the door blocker from the stopping point and rotate to the initial
position
5.2

Application with sliding door ICMs

Step 1: Open the left door (same procedure also for right door)
Step 2: Lift up and rotate the door blocker towards the cabin (as shown in the picture)
Step 3: Place door blocker vertical to door guides (as shown in the picture). Door blocker will be
blocked at door guides walls and prevent the door to close.
Step 4: Release the door blocker from the stopping point and rotate to the initial position
*
optional feature
16
*