To switch the primary video display output from the integrated graphics card to the discrete graphics card,
do the following:
1. Turn on or restart your computer.
2. Before Windows starts up, repeatedly press and release F1 or Fn+F1 (depending on the keyboard
settings) until the Setup Utility program opens. If a BIOS password has been set, enter the correct
password when prompted.
3. Locate the Select Active Video submenu and select PEG. Then press F10 to save changes and exit.
4. Connect the discrete-graphic-card connector on the computer with the DisplayPort or HDMI connector
of the TIO monitor using an applicable dongle.
5. Press the mode-switching button on the TIO monitor to change from the TIO mode to the DP mode or
HDMI mode.
When the computer works with the discrete graphics card, pressing the power button on the TIO monitor
only turns on or turns off the TIO monitor. Devices connected to the TIO monitor do not function the same as
they are connected to the computer.
Supported TIO monitor models:
• Tiny-in-One 23 (MT: 10DQ)
• Tiny-in-One 22 (MT: 10LK)
• Tiny-in-One 24 (MT: 10LL)
• TIO22Gen3 (MT: 10R1)
• TIO22Gen3Touch (MT: 10R0)
• TIO24Gen3 (MT: 10QY)
• TIO24Gen3Touch (MT: 10QX)
Viewing and changing security settings in the Setup Utility program
To view and change security settings in the Setup Utility program, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on page 25.
2. Select Security.
3. Follow the instructions on the right side of the screen to view and change security settings. You can refer
to "Using the Setup Utility program" on page 25 to get basic information about some major security
settings.
4. To save settings and exit the Setup Utility program, press F10 or Fn+F10 (depending on the keyboard
settings). Then, select Yes in the window displayed, and press Enter.
Using passwords and Windows accounts
You can use BIOS passwords and Windows accounts to prevent unauthorized access to your computer and
data. To use the BIOS passwords or the Windows accounts, do the following:
• To use BIOS passwords, see "Using BIOS passwords" on page 28.
• To use Windows accounts, do the following:
1. Click the Start button to open the Start menu.
2. Click Settings ➙ Accounts.
3. Follow the instructions on the screen.
22
P330 Tiny User Guide