Table of Contents
Advertisement
2.1 SYSTEM SIGNAL FLOW & CONNECTIONS
Above is a simple diagram showing how a SAT 265 / SUB 212 system
may be wired for a stereo applications. The system shows a full-range
source (the console) is wired to a SUB 212 subwoofer and from there the
subwoofer outputs are connected to the inputs on the SAT 265.
Multiple Subs:
The diagram above also shows the optional use of multiple subwoofers.
Multiple subwoofers can be used to increase SPL and improve the LF
response of the system, by placing the subwoofers so as to smooth out
the LF response at the mix / monitoring position. Please note that we
recommend that you run the subs in MONO, by using the subwoofer out on
the main sub and then feeding the next sub in the chain.
We do not recommend running stereo subwoofers, because the LF response
in the room will not be as consistent using this method. This is because
electrical summation of the LF signals (as is done with bass-management
using a mono subwoofer / LF signal), is a very predictable and repeatable
way to get consistent LF response. LF phase issues between channels are
resolved in the most absolute and accurate way - electrically.
SAT 265
USER MANUAL • 7 • SYSTEM SIGNAL FLOW & CONNECTIONS
SAT 265
R
Blue Sky International
70 Sea Lane
active monitor
Farmingdale, NY 11735
www.abluesky.com
3 x 100W
tri-amplified
INPUT
-3
REF
GAIN
-6
-9
-12
MAX INPUT +24 dBu
800mv = 90 dB/1m
MAX INPUT +12 dBu
200mv = 90 dB/1m
BAFFLE
-5
COMPENSATION
-3
-2
-1
2
TWEETER
1
LEVEL
-1
-2
WARNING:
To reduce the risk of fire or electrical
shock, do not expose this equipment to rain or
moisture. Do not remove cover. No user serviceable
parts inside. Refer servicing to qualified personnel.
CAUTION
!
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
POWER
ON
115V
230V
115/230 VAC
WARNING:
6.0A T
3.15A T
50/60HZ
SET VOLTAGE
250V
250V
375 WATTS
SWITCH BEFORE
TURNING ON
POWER
Replace Only with Same
Rating and Type
designed in the USA
made in China
Left SAT 265
Monitor Output
(going to the bass-management
inputs on the SUB 212, SUB 12 or SUB 15)
User Manual • System Signal Flow & Connections • Page 9
Right Channel
80Hz bass-managed output
(going to the input on the right SAT 265)
RIGHT
RIGHT
LEFT
LEFT
SUB
SUB
SUB
R
IN
OUT
IN
OUT
IN
OUT
GAIN
REF
blue sky international
70 Sea Lane
Farmingdale,
New York, 11735
USA
www.a bluesk y.com
sub 212 | 400-watt active subwoofer
CAUTION
VOLTAGE
ON
!
Replace Only With Same
RISK OF ELECTRIC SHOCK
SELECTOR
Rating and Type
DO NOT OPEN
WARNING:To reduce the risk of fire or electrical shock,
do not expose this equipment to rain or moisture.
Do not remove cover. No user serviceable parts inside.
Refer servicing to qualified personnel.
AVIS: RISQUE DE CHOC ELECTRIQUE
WARNING:
T 4AL 250V FOR 230V INPUT
NE PAS OUVRIR
SET VOLTAGE
T 8AL 250V FOR 115V INPUT
115/230 50/60 Hz 800W
SWITCH BEFORE
designed in the USA
made in China
TURNING ON
SUB 212, SUB 12 or SUB 15
(SUB 212 shown)
RIGHT
RIGHT
LEFT
LEFT
R
IN
OUT
IN
OUT
blue sky international
70 Sea Lane
Farmingdale,
New York, 11735
USA
www.a bluesk y.com
sub 212 | 400-watt active subwoofer
CAUTION
!
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING:To reduce the risk of fire or electrical shock,
do not expose this equipment to rain or moisture.
Do not remove cover. No user serviceable parts inside.
Refer servicing to qualified personnel.
AVIS: RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
designed in the USA
Optional additional subwoofers
(for best results, use identical subs)
Cable and connector wiring:
Use high-quality, shielded cables to connect your console, workstation or
other sources to your SAT 265 / SUB 212 system. Foil-shielded cables,
such as Belden 8451, 8761, or 9501 should do quite well. Other high
quality cables are available and those that incorporate better shielding will
yield an overall higher noise rejection, lowering your systems susceptibility
to external interference. Another important tip to keep in mind when wiring
your system is to route all line level cables away from the AC and other
power sources, this will reduce the probability of having AC hum emanating
from your monitoring system.
SAT 265
R
Blue Sky International
70 Sea Lane
active monitor
Farmingdale, NY 11735
www.abluesky.com
3 x 100W
tri-amplified
INPUT
-3
REF
GAIN
-6
-9
-12
MAX INPUT +24 dBu
800mv = 90 dB/1m
MAX INPUT +12 dBu
200mv = 90 dB/1m
BAFFLE
-5
COMPENSATION
-3
-2
-1
2
TWEETER
1
LEVEL
-1
-2
WARNING:
To reduce the risk of fire or electrical
shock, do not expose this equipment to rain or
moisture. Do not remove cover. No user serviceable
parts inside. Refer servicing to qualified personnel.
CAUTION
!
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
POWER
ON
115V
230V
115/230 VAC
WARNING:
6.0A T
3.15A T
50/60HZ
SET VOLTAGE
250V
250V
375 WATTS
SWITCH BEFORE
TURNING ON
POWER
Replace Only with Same
Rating and Type
designed in the USA
made in China
Right SAT 265
SUB OUT to SUB IN
(optional)
Optional
additional
subwoofers
SUB
SUB
SUB
IN
OUT
GAIN
REF
VOLTAGE
ON
Replace Only With Same
SELECTOR
Rating and Type
WARNING:
T 4AL 250V FOR 230V INPUT
SET VOLTAGE
T 8AL 250V FOR 115V INPUT
115/230 50/60 Hz 800W
SWITCH BEFORE
made in China
TURNING ON
Advertisement
Table of Contents
