Table of Contents
Advertisement
1.
Dual 6.5", high–excursion, woofers with vented motor, cast
aluminum frame, 1.5 inch aluminum voice coil, copper shorting
rings for lower distortion and ultra low power compression. The
cones for the woofers are made of mica filled polypropylene and
feature a durable and long lasting rubber surround. Both woofers
are also fully video shielded.
2.
1" tweeter, featuring a dual ring radiator diaphragm with integral
waveguide, high-power ferrite motor structure along with full
video shielding.
3.
1/4 x 20 Mounting Inserts (located on the bottom of the SAT
265) - Inserts / hole patterns, compatible with OmniMount®
Type 60 brackets are located on the bottom of the SAT
265.
These brackets are designed to support up to 60
pounds of weight when properly installed.
www.omnimount.com for more information, including detailed
mounting instructions.
Specifications & Dimensions] for more information on insert
locations.
Also see page 3 [Safety Instructions] item 17
"MOUNTING".
4.
Located on the electronics panel on the back of the SAT
265:
Baffle Compensation - The SAT 265 includes four primary
baffle compensation settings, each of which reduces the MF to
LF "bump" that typically results from mounting a speaker in a
baffle wall. The amount of compensation needed is dependent on
room acoustics, along with the size and type of baffle wall. The
only way to accurately determine the amount of compensation
needed is to use a high resolution acoustic analyzer, such as
MLSSA, TEF, etc. For more information please see page 6 & 7 [A
Tour of the SAT 265 Amplifier & Electronics].
Tweeter Level Controls - The SAT 265 includes +/- 3dB of
tweeter level adjustments, in 1dB increments. The switches are
additive, so in order to increase the level of the tweeter by 3dB
set both the 2 and 1dB switches to the UP position. We highly
recommend that you only change these settings, from the "flat"
position, as a last resort and only after doing proper acoustics
treatment of the room and ensuring proper placement of the SAT
265. For more information please see page 6 & 7 [A Tour of
the SAT 265 Amplifier & Electronics] and page 14 [Measurement
Data].
SAT 265
USER MANUAL • SAT 265 FEATURES OVERVIEW
Please visit
Please see page 13 [Technical
1
2
1
3
Input gain and level controls - The SAT 265 includes both a
continuously variable input gain control and individual 10dB input
pads. This allows the user to adjust the gain from REF (200mv
of 500 to 2kHz pink noise = 90dB SPL @ 1M) to -22dB. For
more information please see page 6 & 7 [A Tour of the SAT 265
Amplifier & Electronics].
User Manual • SAT 265 Features Overview • Page 5
4
Advertisement
Table of Contents
