Table of Contents
Advertisement
Installation (continued)
If at any time the bottom supporting ring becomes
disengaged from the body of the waste disposer, then:
1 . Align the slot in the bottom supporting ring with tab on
the waste disposer body .
2 . Lower the bottom supporting ring and make the slot
fit in the tab.
3 . Turn the bottom supporting ring counter clockwise to
secure it in place .
ATTACHING DISCHARGE ELBOW
- Make sure the elbow gasket is attached to the
discharge elbow correctly (see Fig . 9a) .
- Connect the discharge elbow to the disposer
(see Fig . 9) .
REMOVING KNOCKOUT PLUG
If you are using a dishwasher, complete the following procedure . If no dishwasher is to be
connected, skip this section .
- Using a blunt instrument (steel punch or wooden dowel), knock out the entire plug
(see Fig . 10) . Do not use a screwdriver or sharp instrument . When the knockout
plug falls into the disposer, you may remove it, or grind it up when the disposer is
being used . This will not damage the disposer in any way, but may take some time
to grind .
Slot
Tab
Elbow Gasket
Groove
Discharge Elbow
Fig . 9a
7
Please contact cs@conglomkb.com or +61 2 87245218 for further assistance .
Fig . 9
Knockout
Plug
Wood or
Fig . 10
Metal Dowel
CONGLOMKB .COM
Advertisement
Table of Contents
