Table of Contents
Advertisement
Installation (continued)
If at any time the bottom supporting ring becomes disengaged
from the body of the waste disposer, then:
1 . Align the slot in the bottom supporting ring with tab on the
waste disposer body .
2 . Lower the bottom supporting ring and make the slot fit in the
tab .
3 . Turn the bottom supporting ring counter clockwise to secure it
in place .
ATTACHING DISCHARGE ELBOW
- Make sure the elbow gasket is attached to the discharge elbow
correctly (see Fig . 9a) .
- Connect the discharge elbow to the disposer
(see Fig . 9) .
REMOVING KNOCKOUT PLUG
(SKIP THIS STEP IF YOU DO NOT HAVE A DISHWASHER)
NOTE:
Not recommended for use in Australia and New Zealand.
The dishwasher connector of this waste disposer is not recommended
for use in Australia and New Zealand. It is recommended to connect the
diswasher using IPLEX / CAROMA dishwasher connectors for optimal
performance in these regions instead.
Once removed, the knockout plug cannot be replaced.
- Using a blunt instrument (steel punch or wooden dowel), knock
out the entire plug (see Fig . 10) . Do not use a screwdriver
or sharp instrument . When the knockout plug falls into the
disposer, you may remove it, or grind it up when the disposer is
being used . This will not damage the disposer in any way, but
may take some time to grind .
Slot
Tab
Elbow Gasket
Fig . 9a
Fig . 9
Knockout Plug
7
Please contact 0800 744 794 for further assistance .
Groove
Discharge Elbow
Wood or
Metal Dowel
Fig . 10
WWW .ACMPTYLTD .COM
Advertisement
Table of Contents
