Connecting The Battery - Toro Greensmaster Flex 1800 Series Installation Instructions Manual

7
Finishing the Light Kit
Installation
No Parts Required
Installing the Control-Panel Cover
1. Align the keyhole slot in the control-panel cover over
the traction and reel drive handle
Figure 15
1. Traction and reel drive
handle
2. Keyhole slot (control-panel
cover)
2. Align the holes in the control-panel cover to the holes
in the support bracket of the handle bar
3. Assemble the cover to the bracket
4 flange-head screw (1/4 x 1/2 inch) that you removed
in step 1 of (page ).
4. Tighten the screws by hand.
(Figure 15).
3. Flange-head screw (1/4 x
1/2 inch)
4. Support bracket (handle
bar)
(Figure 15).
(Figure 15) with the
Connecting the Spark-Plug Wire
Flex 1800 and 2100 Series Machines
Connect the spark-plug wire to the terminal of the spark
plug; refer to Figure 1 of
(page 2).

Connecting the Battery

eFlex 1800 and 2100 Series Machines
Connect the T-handle connector of the battery adapter-wire
harness to the P04 connector of the battery-wire harness;
refer to Figure 2 of Disconnecting the Battery (page
9
Disconnecting the Spark-Plug Wire
2).