Toro Greensmaster Flex 1800 Series Installation Instructions Manual page 7

Connecting the Wire Harness to the
Wire Harness of the LED Light and
Wireless Hour Meter Harness Kit
Flex 1800 and 2100 Series Machines
Note: The 2-position rocker switch with a 10-pin connector
is installed in the LED light and wireless hour meter harness
kit.
1. Align the 2 socket connector of the wire harness for
the LED light and wireless hour meter harness kit with
the 2 pin connector of the wiring harness of the LED
light kit (Figure 11).
1. 2-position rocker switch—
10-pin connector (installed
in the LED light and
wireless hour meter
harness kit)
2. 2-pin connector (wire
harness—LED light kit)
2. Connect the 2 socket connector of the light-kit harness
to the 2 pin connector of the LED light and wireless
hour meter harness
Note: Ensure that the connectors are fully seated and
the latch of the connectors snap together securely.
Figure 11
3. 2-socket connector (wire
harness—LED light and
wireless hour meter
harness kit)
(Figure 11).
Connecting the Wire Harness to the
Wire Harness of the Machine
eFlex 1800 and 2100 Series Machines
1. Align the 2-socket connect of the wire harness for
the machine with the 2-pin connector of the light-kit
harness (Figure 12).
1. Plug
2. 2-pin connector (light-kit
harness)
2. Connect the 2-socket connect of the wire harness for
the machine with the 2-pin connector of the light-kit
harness (Figure 12).
Note: Ensure that the connectors are fully seated and
the latch of the connectors snap together securely.
6
Installing the Light Switch
eFlex 1800 and 2100 Series Machines
Parts needed for this procedure:
1 2-position rocker switch
Procedure
1. Remove the plug from the opening at the left face of
the control panel
7
Figure 12
3. 2-socket connect (wire
harness of the machine)
(Figure 13).