Toshiba RAV-GV1601AT8P-E Service Manual page 11

Only a qualified installer ( 1) or qualified service person ( 1) is allowed to install the air
conditioner. If the air conditioner is installed by an unqualified individual, a fire, electric shocks,
injury, water leakage, noise and/or vibration may result.
Before starting to install the air conditioner, read carefully through the Installation Manual, and
follow its instructions to install the air conditioner.
Do not install the air conditioner in a location that may be subject to a risk of expire to
a combustible gas. If a combustible gas leaks and becomes concentrated around the unit, a fire
may occur.
When transporting the air conditioner, use a forklift and when moving the air conditioner
Installation
by hand, move the unit with 4 people.
Install a circuit breaker that meets the specifications in the installation manual and the stipulations
in the local regulations and laws.
Install the circuit breaker where it can be easily accessed by the agent.
Do not place any combustion appliance in a place where it is directly exposed to the wind of air
conditioner, otherwise it may cause imperfect combustion.
When carrying out the pump-down work shut down the compressor before disconnecting the
refrigerant pipe. Disconnecting the refrigerant pipe with the service valve left open and the
compressor still operating will cause air, etc. to be sucked in, raising the pressure inside the
refrigeration cycle to an abnormally high level, and possibly resulting in reputing, injury, etc.
When removing the welding parts of suction and discharge pipe for the compressor, remove
Compulsion
them at the place ventilated well after recovering the refrigerant. Improper recovering may cause
the spurt of the refrigerant and the refrigeration oil, causing a injury.
Do not vent gases to the atmosphere.
Venting gases to the atmosphere is prohibited by the law.
Prohibition
CAUTION
Ensure wearing of gloves when performing any work in order to avoid injury from parts,
etc. Failure to wear the proper protective gloves cause a injury due to the parts, etc.
Wearing of
gloves
When performing the welding work, check whether refrigerant leaks or remains.
If the leakage refrigerant gas touches a fire source, it may generate noxious gases, causing a fire.
Confirm
- 11 -