Toshiba RAV-GV1601AT8P-E Service Manual page 103

Step Component
4 Exchange of
electric parts
(Continued)
Procedure
20) Remove the ASM-S-BASE-CDB out of
the ASM-INV-SUB (Fig. 4-19)
21) Remove the all connectors and screws
(Screws:M4x8, 4pcs.) (Fig. 4-20)
21) Remove the screws of IC21 and DB01
(Screws:M4x16, 2pcs.) and
(Screws:M3x14, 2pcs.) (Fig. 4-21)
22) Remove the screw of SPACER
(Screw:M3x20, 1pc.) (Fig. 4-21)
23) Cut the binding band (Fig. 4-21)
24) Remove the ASM-PCB(IPDU) of support
spacers 6 positions (Fig. 4-22)
24) Remove the SPACER(BUSH) and
SPACER(COLLAR) out of the ASM-PCB
(IPDU) (Fig. 4-22)
25) ASM-PCB(IPDU) (Fig. 4-23)
2.2. Attachment
1) Install it in the reverse of the procedure
to remove it.
2) Apply heat silicones to E-parts.
(Fig. 4-24)
Note: Mounting torque of Screw:M3 is
0.4~0.6 N·m and Screw:M4 is 1.1~1.3 N·m.
- 103 -
Remark
Slide
(Fig. 4-19)
Connectors
Connectors
(Fig. 4-20)
Screw M3
& Spacer
Screws M4
of IC21
Screws M3
of DB01
binding band
(Fig. 4-21)
Spacers
(Bush, Collar)
Spacers
(Fig. 4-22)
WP-508
(Fig. 4-23)
Heat Silicones
(Fig. 4-24)
Screws