Chevrolet Bolt EUV 2023 Owner's Manual page 56

Chevrolet Bolt EUV Owner Manual (GMK-Localizing-MidEast-16409246) -
2023 - CRC - 4/7/22
56 Seats and Restraints
Warning
Children can be seriously injured or
strangled if a shoulder belt is wrapped
around their neck.
Buckle any unused seat belts behind the
child restraint so children cannot reach
them. Pull the shoulder belt all the way
out of the retractor and tighten the belt
behind the child restraint after the child
restraint has been installed.
Caution
Do not let the LATCH attachments rub
against the vehicle s seat belts. This may
damage these parts. If necessary, move
buckled seat belts to avoid rubbing the
LATCH attachments.
Do not fold the rear seatback when the
seat is occupied. Do not fold the empty
rear seat with a seat belt buckled. This
could damage the seat belt or the seat.
Unbuckle and return the seat belt to its
stowed position, before folding the seat.
If you need to secure more than one child
restraint in the rear seat, see Where to Put
the Restraint 0 51 for additional information.
1. Attach and tighten the lower
attachments to the lower anchors. If the
child restraint does not have lower
attachments or the desired seating
position does not have lower anchors,
secure the child restraint with the top
tether and the seat belts. Refer to your
child restraint manufacturer instructions
and the instructions in this manual.
1.1. Find the lower anchors for the
desired seating position.
1.2. Put the child restraint on the seat.
For rear outboard seating positions,
if the head restraint interferes with
the proper installation of the child
restraint, the head restraint may be
removed. See Head Restraint
Removal and Reinstallation at the
end of this section.
When installing a rear-facing child
restraint, it may be necessary to
move the front seat forward to
properly install the child restraint
per the child restraint manufacturer
instructions.
1.3. Attach and tighten the lower
attachments on the child restraint
to the lower anchors.
2. If the child restraint manufacturer
recommends that the top tether be
attached, attach and tighten the top
tether to the top tether anchor,
if equipped. Refer to the child restraint
instructions and the following steps:
2.1. Find the top tether anchor.
2.2. Remove the cargo cover before
installing the top tether. Place the
cargo cover in its original location
after installing your child restraint
when the head restraint is removed.
2.3. Route, attach, and tighten the top
tether according to your child
restraint instructions and the
following instructions: