Table of Contents
Advertisement
1.Error status indicator
If your refrigerator does not cool
adequately or if there is a sensor failure,
this indicator
(
) will be activated. When this
indicator is active, Freezer Compartment
Temperature indicator will display "E"
and Fridge Compartment Temperature
Indicator will display numbers such
as "1,2,3...". These numbers on the
indicator provide information about the
error to the service personnel.
When you place hot food into the
freezer compartment or if you leave the
door open for a long time, exclamation
mark can illuminate for some time.
This is not a failure; this warning will
disappear when the food cools down.
2. Energy saving function (display
off) indicator
If the product doors are kept closed
for a long time energy saving function
is automatically activated and energy
saving symbol is illuminated. (
When energy saving function is
activated, all symbols on the display
other than energy saving symbol
will turn off. When the energy saving
function is activated, if any button is
pressed or the door is opened, energy
saving function will be canceled and the
symbols on display will return to normal.
Energy saving function is a factory
default and cannot be cancelled.
3. Quick fridge key
Quick fridge indicator (
the fridge compartment temperature
indicator value is displayed as 1 when
the quick fridge function is activated.
To cancel this function, press the
Quick fridge button again. Quick fridge
indicator will be off and the refrigerator
will be reset to its normal settings.
Quick fridge function is cancelled
automatically in 1 hour if you do not
cancel it. If you want to cool large
amounts of fresh food, press the Quick
fridge button before putting the food
into the fridge compartment.
4. Fridge compartment
temperature setting button
When this button is pressed the fridge
compartment temperature can be set
to 8,7,6,5,4,3,2 and 1 values. ( )
5.Wireless connection (*optional)
key
This button is used to make a wireless
connection to your product via the
HomeWhiz mobile application.
By long pressing the button (3
seconds), the wireless icon on the
display / indicator flashes slowly (at 0.5
second intervals). The first introduction
of the home network to the product is
started in this way.
After the wireless connection is
established with the product, the
)
wireless connection icon (
constantly.
After completing the initial setup,
the connection can be activated/
deactivated by pressing this button.
The wireless icon flashes fast (at 0.2
second intervals) until the connection
is established. When the connection is
active, the wireless network icon lights
continuously.
If the connection cannot be established
for a long time, check your connection
) is lit and
settings and see the 'Troubleshooting'
section in the user manual.
HomeWhiz
be used for wireless connection.
Installation steps are explained through
the application during installation.
16
EN
) lights
application
should
Advertisement
Table of Contents
