MB QUART MBQR-RAD-2 Instruction Manual page 7

DASH AREA DISASSEMBLY 2018.5 Turbo S & 2019+ RZR - Continued
STEP 7 – PREPARE FINAL ELECTRONICS FOR DASH REMOVAL
Gently remove the plastic nut holding the ignition switch to the dash as shown in Figure 7-7a. Next,
disconnect wires from back of switches as shown in Figure 7-7b. Take note of plug color and switch location
for reassembly purposes.
Figure 7-7a
STEP 8– REMOVE DASH FASCIA
Gently pull dash fascia toward seat to remove as shown
in Figure 7-8. Set aside in a safe location until it's time
for reassembly. This allows further access for running
wires.
NEXT STEPS
Refer to the MBQR-RAD-2 Operator's Guide and Installation Instructions for wiring and fitting details. This is
available at MBQuart.com.
MBQR-RAD-2
®
AM/FM/USB/Bluetooth
Multimedia Controller and
for Polaris ® RZR ® Vehicles
Operator's Guide and
Installation Instructions
MBQR-RAD-2
Operator's Guide and
Installation Instructions
7
Figure 7-7b
Figure 7-8