MB QUART MBQR-RAD-2 Instruction Manual page 4

DASH AREA DISASSEMBLY 2013-2018 (Non-Turbo S) RZR - Continued
STEP 5 – REMOVE DASH FASCIA CENTER HARDWARE
Remove (4) Torx screws from the front of the dash through the openings shown in Figure 5-6. The first set of
Torx screws will come out allowing access to the second (upper) set further back in the dash. Next, pull the
only the center of the dash loose as shown in Figure 5-7.
Figure 5-6
STEP 6 – REMOVE DASH FASCIA HARDWARE
Using a large panel removal tool, release the side clips from the passenger's side front dash assembly as
shown in Figures 5-8 and 5-9. Slowly ensure you account for all clips removed.
Figure 5-8
NEXT STEPS
Refer to the MBQR-RAD-2 Operator's Guide and Installation Instructions for wiring and fitting details. This is
available at MBQuart.com.
Figure 5-9
MBQR-RAD-2
AM/FM/USB/Bluetooth ®
Multimedia Controller and
for Polaris RZR Vehicles
® ®
Operator's Guide and
Installation Instructions
MBQR-RAD-2
Operator's Guide and
Installation Instructions
4
Figure 5-7
©2020 Maxxsonics USA, Inc.