MB QUART MBQR-RAD-2 Instruction Manual page 53

SETTINGS Menu (Continued)
Clock Adjust
● Access the clock adjust mode menu
to change the time displayed on the
unit's main screen.
● Navigate each time parameter (hour,
then minute) by turning the knob and
select by pushing the knob.
● Adjust the hour parameter as desired,
Clock Adjust Screen
then push the knob again to move to minutes.
● AM or PM settings are automatically determined by the clock mode
settings (12 or 24 hour format).
● Use the SOURCE button to close the clock adjust screen when
complete and return to the main menu.
Backlight
● Access the backlight menu to adjust
the brightness of the screen lighting.
● Verify preferred setting with the
check marked choice.
● Use the SOURCE button to close
the backlight screen when complete
Backlight Adjust Screen
and return to the main menu.
Version
● This menu reports the software version in the unit. No settings or
changes are available to the user.
AUDIO Settings Sub-Menu
Access the "Audio" menu and the following adjustments are available:
SUB Frequency
● Adjust the low pass crossover for the SUB preamp (green) RCA
outputs. The choices are 80Hz, 100Hz and 120Hz.
SUB Level
● Adjust the relative volume level for the SUB preamp (green) RCA
outputs in a range of 0 (fully attenuated) to 40 (fully open).
ZONE Level
● Adjust the relative volume level for the front/rear preamp RCA outputs
in a range of 0 (fully attenuated) to 40 (fully open). The unit's built-in
power and SUB levels are unaffected by this adjustment. Only the front/
rear preamp outputs are controlled by the zone volume. See page 20-
21 for example system diagrams utilizing zone control.
18