Stratco SS-10367 Assembly Manual

Each shelf can hold a maximum load of 45kg. Please carefully read and follow these
instructions to assemble your cabinet.
ENSURE PROTECTIVE EYEWEAR AND GLOVES ARE WORN WHEN ASSEMBLING THIS UNIT.
WARNING: SERIOUS INJURY CAN BE CAUSED BY TOPPLING FURNITURE. To help
prevent tip-over, we recommend you anchor this product to a wall or other suitable surface. Check anchors regularly.
Step 1

CHECK PARTS LIST

Tools required:
1 x Phillips
Screwdriver
1 x Rubber Mallet
Step 2
FITTING AND
SECURING REAR
WALL TO SIDES
C
M
Step 3
Y
CM
FITTING FRONT
MY
PANEL TO SIDE
CY
PANELS
CMY
K
Step 4
FITTING AND
SECURING
TOP PANEL
1
JUNE 2023
EXTRA WIDE
METAL CABINET
1 x Front Panel (Doors & Frame)
2 x Plastic Covers
10 x Screws
A B
Position the Right Side Panel View from above of
next to the Rear Wall. how they slot together.
A B
Slide Front Panel into the two sides and click into place.
A
Locate the Top Panel - the front has the 'push-through' slots.
Lift the Top Panel into place from the inside.
1 x Rear Wall
(install this way up & face
detail towards inside of cabinet)
16 x Shelf Supports
2 x Keys
C
Secure with screws to hold
side and rear together.
B
Fasten to the Back Panel with 3 x screws. Then, use a screwdriver to
push the 'push-through' slots shown at 'A' into the Front Panel.
FOR INTERNAL USE ONLY
SS-10367
1 x Top Panel
3 x Shelves
(have folded edge)
2 x Side Panel
1 x Floor Panel
D
Repeat with other side.