Stratco HW-13318 Assembly Manual

THANK YOU FOR PURCHASING YOUR 2 DOOR METAL STORAGE CABINET.
Each shelf can hold a maximum load of 45kg. Please carefully read and follow these
instructions to assemble your cabinet.
ENSURE PROTECTIVE EYEWEAR AND GLOVES ARE WORN WHEN ASSEMBLING THIS UNIT.
Step 1
CHECK PARTS LIST
TOOLS REQUIRED:
• Phillips Head
Screwdriver
There may be minor variations in the
appearance of some parts from
illustrations due to continued
product improvements.
Step 2
C
M
C
Y C
M
CM
M
Y
MY
Y
Stand the back and right
CY
CM
CM hand side upright.
CMY
MY
MY
K
CY
Step 5
CY
CMY
CMY
K
K
Insert the cupboard door section
from the inside of the unit.
1
JUNE 2022
2 DOOR METAL
STORAGE UNIT
1 x Front Panel
(Doors & Frame)
2 x Plastic Covers
Fit bottom shelf making sure side slots line up
and that the front of the shelf sits on the lip.
TIP
• Get your components ready ahead of the next procedure.
• Use care when using an electric screwdriver not to strip the thread on the screwholes.
1 x Rear Wall
(install this way up & face
detail towards inside of cabinet)
10 x Screws 8 x Shelf Supports
Step 3
Screw in top and middle screws
to secure Back and RH Side.
Step 6
HW-13318
Top
2 x Middle Shelf
2 x Side Panels
Bottom Shelf
2 x Keys
Step 4
Repeat for LH Side.
Step 7
Lay unit on it's back and fix
bottom screw in lower shelf.