Stratco HT-6799 Assembly Manual

THANK YOU FOR PURCHASING YOUR SECURITY MESH METAL CABINET.
Please carefully read and follow these instructions to assemble your cabinet.
ENSURE PROTECTIVE EYEWEAR AND GLOVES ARE WORN WHEN ASSEMBLING THIS UNIT.
Step 1
CHECK PARTS LIST
TOOLS REQUIRED:
• Phillips Head
Screwdriver
C
M
Y
CM
MY
CY
CMY
Step 2
K
C
FITTING AND
M
SECURING REAR
Y
WALL TO SIDES
CM
MY
CY
CMY
K
C
M
Step 3
Y
CM
FITTING FRONT
MY
PANEL TO SIDE
CY
PANELS
CMY
K
C
M
Y
CM
Step 4
MY
CY
FITTING AND
CMY
SECURING
K
TOP PANEL
1
JUN 2022
SECURITY MESH
METAL CABINET
1 x Front Panel (Doors & Frame)
2 x Plastic Covers 10 x Screws
A B
Rear wall should be positioned
inside the cabinet and then
slotted into the side panel.
A
Front panel slots
into side when
bottom corner
lines up.
A B
Push top panel into opening as shown.
Ensuring the flaps are facing the front
and screw holes are facing the back.
1 x Rear Wall
(install this way up & face
detail towards inside of cabinet)
16 x Shelf Supports
C
Figure C is a view from
above of how they fit.
B C
Take careful note of slot position.
It should be located at the front
bottom corner of the cabinet.
C
Secure top panel with screws at 1, 2
and 3. Make sure that the top panel
is flush with the top of the cabinet.
FOR INTERNAL USE ONLY
HT-6799
3 x Shelves
(shelves have folded edge)
2 x Side Panel 2 x Floor Panel/Top Panel
(no folded edge)
2 x Keys
D E
Repeat this on the other Once the rear wall is in
side (if necessary open place, secure with screws
Doors and push rear at points 1, 2, 3, 4 5 and 6.
wall into alignment).
D
Push against
back of front
panel to
secure.
Repeat other side.
D E
To finish securing top, the two small
flaps at the front of the cabinet (D)
must be bent in as shown in Figure E.