Operations - Bissell CLEANVIEW 1837 Series User Manual

Operations: Power On & Settings
1
Push the Red Power Switch Pedal
to turn the unit ON and once again to
turn the unit OFF.
3
Turn the dial on the foot of the vacuum to the desired
setting. If the dial is difficult to turn, tilt the vacuum back
slightly to take the weight off the foot while turning.
Lowest setting –
Medium setting – For medium pile carpet.
Highest setting – For high pile and most shag carpet.
WARNING
To reduce the risk of injury from moving parts while the vacuum is turned on, always move the
vacuum via the rolling wheels by using the upper handle at the back of the vacuum. Do not carry
the vacuum while it is running. Always place vacuum on floor with handle in upright position
when using tools.
NOTE: The rotating floor brush continues to rotate while tools are in use. Never place your
fingers under the vacuum when it is running. Never place powerfoot on furniture or uneven
surfaces. Do not place vacuum close enough to objects to pull them into rotating brush.
NOTE: Certain carpets and low humidity conditions may generate small static discharges.
Static discharges are entirely harmless and are not associated in any way with the main
power supply.
6
www.BISSELL.com
once
For low pile carpet or bare floors.
To pick up debris, it may be necessary
to move up one setting.
2
Press the recline pedal and pull handle
back towards you.
TIP: For optimal carpet
cleaning performance,
adjust to the lowest
practical setting.
If your vacuum is difficult
to push, adjust to the
next higher setting.