Stamina inTONE Plus Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
STEP 4
Refer to the position of the legs as shown in
illustration 4. First, screw the two LEGS(7) with
Warning Labels into the threaded connectors on
the rail frame. Next, attach the remaining four
LEGS(7).
STEP 5
Place the trampoline in the normal use position. Remove
the LEG CAP(8) from the LEG(7) as shown in illustration
5. Loosen the LOCKING KNOB(24) on the SENSOR
DETECTOR(21) to allow the LEG(7) to slide through
the hole in the SENSOR DETECTOR(21). Slide the
SENSOR DETECTOR(21) onto the LEG(7) and slide
up until it touches the rail frame. Adjust the position of
the SENSOR DETECTOR(21) so that the tip is slightly
touching the bottom of the MAT(5). Be sure the SENSOR
DETECTOR(21) is not pressed firmly against the bottom
of the mat or bent downward. If it is not adjusted correctly,
there is a chance that the SENSOR DETECTOR(21) won't
work properly or that the arm will break during use. Lock the
SENSOR DETECTOR(21) in position with the LOCKING
KNOB(24). Press the LEG CAP(8) back on the LEG(7).
STEP 6
Install an AA battery into the METER(20), battery is not
included. See page 12 for detailed battery installation
instructions. Slide the METER(20) onto the MOUNTING
BRACKET(22). Plug the sensor wire on the SENSOR
DETECTOR(21) into the back of the METER(20).
Warning
Label
Attach Resistance Tube
on this Leg.
8
Warning
Label
Attach
Resistance Tube
on this Leg.
Attach Meter
on this Leg.
Tip
4.
5.